How to connect to the SBG IMU board?

  • Use the provided ethernet cable to connect LiDAR to your PC
  • Switch LiDAR on
  • Set PC to static IP address:
    • Open Control Panel -> Network and Internet -> Network and Sharing Center -> Change adapter settings
    • Right click on the ethernet adapter and go to “Properties” in admin
    • Select “Internet Protocol version 4 (TCP/IPv4)” and click “Properties” in admin
    • Make sure the Protocol window uses the IP and the default subnet mask ( like the example below
      Capture décran 2024-02-09 151255
    • Click on OK and close
  • Open a web browser and enter the IP address